Colorful portable functional 3 d doodle pen with ABS / PLA 1.75mm filament

Orange 3D Drawing Pen Doodle Painting Tools With AU /EU / US /UK Plug For Kids  

Product Detail

Thank you for buying the 3D pen, in order to have a good 
experience with the pen, please read carefully the operation manual.

Operation manual:

Step 1: Connect your 3D pen to the power adapter
Connect the power adapter to the back of the 3D pen and plug it into a power source. When the yellow LED turns on, the pen is in the preheat status.

Step 2: Allow your 3D pen to heat up before loading filament
Press the \"wire feeding\" button, so the red LED turns on. After 30 seconds, the red LED will turn into green, preheating is done and the pen is ready.

Step 3: Load the pen
Insert the ABS filament into the \"wire loading hole\" which is at the end of the pen. Keep on pressing the \"wire loading\" button,the material will be loaded by built-in motor. Hold till the plastic material comes out from the nozzle nip, so the material loading is finished.

Step 4: Draw & adjust your speed
Keep pressing the wire feeding button and draw your 3D objects. The speed of extrusion is adjustable by speed controller. Releasing the button will cause the pen to stop extruding.
NOTE: The device will switch to standby mode if not being used over 5 minutes, The LED light will be off. If you want to use it again, press the \"wire feeding\" button to restart.

Step 5: Unloading Filament
When you want to unload or change the filament, you should press the wire unloading button, You may need to adjust the speed controller.
NOTE: Unloading the filament after each use is highly recommended. You need to cut the material ending to smooth before loading.

Package

1*3D Printing Pen

20* 5m Printing ABS Filament(Free gift)

1*12V/3A Power Adapter

1*User Manual

You can buy 1 pcs 3d printer pen with 20 free ABS filament 

we can provide AU , EU , US , UK plug