Roll Forming Machine

Pressure-watt machine use and Note: Automatic discharge, whichever billet procedures: Mold test installation and the host with the above, and then open the air compressors, vacuum pumps, extrusion machine, ceva machine, discharge machine, pressure-watt machine host and Vaahto conveyor, parking, the first stop extruding machine, then stop the remaining equipment.
Manually put blank, blank check procedures: In the device before use, to check the connection is solid throughout, install bolts and tighten the nut is the right and left foot should be added to the chassis lubrication oil, in order to conduct a trial run electricity to start the machine before running empty careful observation, with or without vibration, noise, oil window, whether to oil, the various components of movement is coordinated, in order to install all the normal mold, installing dies, we must cut off the power supply, hand moving belt or gear motors, so that transposition table make sliding seat to rise to the highest point, it is best to use an object support on the table and sliding between the seat bottom to the whereabouts of the natural non-slip seat, causing the accident.
The machine used in the mold and mold need a size 6, under the same size die, be installed under the upper die and a mold, mold directly under the wheel is installed in the six-party table, on the model installed in the slide at the end of the surface, and placing the appropriate thickness of the plate to ensure that the upper and lower mold clamping, the four peripheral gap is even, the distance between the upper and lower die is equal to the thickness required for tile blanks. And then to press tile machine mold prevail transposition table, install the remaining five under the die to pay, all installed in order to drive to the upper and lower mold after the pressure watts. Department installed in order to drive to the upper and lower mold after the pressure watts.