ST-R300A Professional 0.8 mm Mini LVLP Air Spray Gun Red Color Suction Type Aluminum Body

Description:

Type:	Mini LVLP Gravity Feed
Nozzle size:	0.8-1.0 mm
Air Consumption:	1.6-4.0 cfm
Inlet Air Pressure:	50-70 PSI
Maximum Pattern Width:	100 mm
Material Capacity:	125 ml
Compressor required:	2-3HP
Air inlet:	1/4\" BSP/NPT

FEATURE: 

1. A LVLP (Low Volume, Low Pressure) Spray Gun can operate at less than 10 psi at the nozzle cap as compared to HVLP which operates at 10 psi at the air cap and is usually pushed higher. 

2. LVLP Spray Gun use of lower volume of air finely atomizes paint creating a smooth finish with minimum overspray. This means very little overspray will be produced, saving on paint cost and environmental hazards. 

3. Stainless steel needle and nozzle accommodate a variety of coatings. 

4. Precise machined air cap set. 

5. Air inlet, paint volume and spraying pattern adjustable. 

6. New ergonomic designed handle for comfortable grip. 

7. Soft, super-fine mist suitable for all kinds of surface. 

8.1 Year limited Warranty. 

Mini LVLP Spray Gun : 

Model No. ----------------------------- ST-R300 
Type of Feed------------------------- Gravity 
Standard Nozzle-------------------- 0.8mm 
Optional Nozzle--------------------- 0.8-1.5mm 
Operationg Pressure-------------- 2.0-3.5bar 
Pattern Width------------------------- 100-150mm 
Air Consumption-------------------- 2.4-3.3 
Paint Capacity------------------------ 120CC

 How to spray:

Surface preparation is as important with a spray gun as with any other kind of paint applicators. For car bodies, the paint is rubbed down with Wet or Dry abrasive paper, used wet. For small areas, the edges must blend in with the existing paintwork. Where paintwork is rubbed down to bare metal, primer must be used.

Once the areas that you don’t want to paint have been masked off, you can start spraying. A spray gun should be kept as horizontal as possible and the nozzle at right-angles to the surface being sprayed. For surfaces other than vertical or near-vertical ones, you can get a flexible extension nozzle or an angle nozzle to allow the gun to be used horizontally.

Spraying is carried out in a series of bands, each of which is done in one ‘pass’ of the gun. It is important to keep the gun al the same distance throughout the pass and that it is moving and spraying as it reaches and leaves the area to be sprayed. This takes a bit of practice which can be done on an old piece of board before starting in earnest.

ST-R100 Professional 0.8 mm  Mini hvlp Air Spray Gun