Circular Saw Pipe Cutting Machine High Speed For Carbon Steel Pipe

Circular Saw Pipe Cutting Machine High Speed For Carbon Steel Pipe

Quick Details

Condition: New                                                                        Place of origin: Jiangsu China

Model Number: MC350D                                                         Machine Type: Pipe and Tube Cutting Machine

Raw Material: Pipe                                                                  Power: Hydraulic

Certification: CE&ISO                                                              Cooling System: water cooling

Machine Overview:

MC350D Metal Pipe Cutting Machine,based on the introduction of foreign advanced technology,innovative and develop a hydraulic automatic sawing machine,Performance of their products reach the advanced level, Sawing various sectional shapes can be ordinary steel, stainless steel, copper, aluminum and other metal profiles,Especially sawing various pipe is ideal. The machine uses hydraulic control,When sawing without artificial feeding, discharging, Its workpiece clamping, release, feed, retract automatically by hydraulic control ,The machining accuracy, high efficiency, suitable for long-term continuous operation.

Cutting Quantity:

The machine is equipped with cutting the number of counters one (on the main control panel),The scheduled number of workpieces sawing input counter,The actual amount of cutting will be displayed on a small screen counter, When the actual number sawing consistent with preset number, the machine will automatically stop working, cutting the number of the actual counter is automatically reset to zero.

Technical Parameters

Configuration Introduction:

Electronic control parts:FR.L and solenoid valve are imported from  Air TAC Taiwan；Valve:Taiwan imported hydraulic Asada；

AC contactor:South Korean imported Shilin；Stop button and the start button is: Taiwan Tiandi；Other electrical accessories: Chint.

Rail: Taiwan Shangyin.

Installation and commissioning

1,The machine must be placed on level ground, four feet with bolts to secure it.

2,Line has been assembled inside the machine debugging, and the power (380V 50Hz, three-phase four current system) connected, while the machine must be grounded to ensure safety.

3,Confirm steering: lights switched on, then the pole-changing switch is turned on (set to \"1\" or \"2\" position), then depress the foot switch motor rotation direction depending on the direction of spindle rotation and cover arrows consistent, If you reverse the swap any two-phase power line phase

Operating Instructions

1. Saw Installation

Depending on the size of the material to be sawn, select the appropriate blade thickness, diameter and number of teeth. After Saw blade selected according to the following steps to install the machine

(1)The power switch is set to OFF.

(2)Open the blade safety cover.

(3)The knife blade cover removed, and the spindle flange, and a knife blade cover with a clean cloth not leave any sand or iron filings.

(4)Mounted on the blade, tooth front cover arrows in the same direction with the knife, put the knife on the cover, tighten the screws, before completely locking the blade to pull the blade turning in the opposite direction, so that the pin face cover tightly knife the pressure on the blade pin hole, then tighten the screws firmly.

(5)Cover the blade safety guard rails, complete blade installation. To remove, against the above steps.

2. Feed stroke depth adjustment

Adjustable limit nut, then turn the control valve closed dot (counterclockwise) so that load slowly head down until the blade can cut the workpiece to be cut up, so