NEMA 34 Closed Loop Stepper Motor System ,70 Volt for Industrial HBS86

Delivery Time:FOR SAMPLES , 7-10 days For batch . 15-25days.
Certification:CE,ROHS ,ISO9001

High speed Closed Loop Stepper Motor System Hybrid Servo Kit NEMA 34  3 Phase

Phase: 3 Phase Structure: Hybrid Peak  Current: 8.2A Rated Voltage: 24-70V Function: Control Speed: Low  or High speed Usage: Industrial Shape: Square  Pulse input frequency :200KHZ

NEMA 34 Closed Loop Stepper Motor System  Hybrid Servo Kit, NEMA34 Hybrid servo motor, HBS86 Hybrid servo driver

The Hybrid Servo Drive offers an alternative for applications requiring high performance and high reliability when the servo was the only choice, while it remains cost-effective. The system includes a 3-phase stepper motor combined with a fully digital, high performance drive and an internal encoder which is used to close the position, velocity and current loops in real time, just like servo systems. It combines the best of servo and stepper motor technologies, and delivers unique capabilities and enhancements over both, while at a fraction of the cost of a servo system.

The Hybrid Servo Drive offers an alternative for applications requiring high performance and high reliability when the servo was the only choice, while it remains cost-effective.

NEMA 34 Hybrid Servo kit (closed-loop stepper system):
one Hybrid Servo Driver HBS86  one NEMA34 JK86-4N-1000 Hybrid Servo Motor with one Encoder 1000 line, one 3 meter cable

A: HBS86, 3-phase Hybrid Servo Drive for NEMA34 Hybrid Servo Motor

Features

Closed-loop, eliminates loss of synchronization Broader operating range – higher torque and higher speed Reduced motor heating and more efficient  Smooth motion and super-low motor noise Do not need a high torque margin  No Tuning and always stable  Fast response, no delay and almost no settle time  High torque at starting and low speed, high stiffness at standstill  Lower cost  24-70V, 8.2A Peak, No Tuning, Nulls loss of Synchronization
Electrical Specifications (Tj = 25oC/77oF)

Parameters	HBS86
Min	Typical	Max	Unit
Output current	0	-	8.2 (Peak)	A
Input voltage	24	36	70	VDC
Logic signal current	7	10	16	mA
Pulse input frequency	0	-	200	kHz
Isolation resistance	500			MΩ

The HBS57 has three connectors, connector for control signals connections, connector for encoder feedback and connector for power and motor connections.

Control Signal Connector - Screw Terminal
Pin	Name	I/O	Description
1	PUL+	I	Pulse signal: In single pulse (pulse/direction) mode, this input represents pulse signal, each rising or falling edge active (software configurable, see hybrid servo software operational manual for more detail); In double pulse mode (software configurable), this input represents clockwise (CW) pulse, active both at high level and low level. 4-5V when PUL-HIGH, 0-0.5V when PUL-LOW. For reliable response, pulse width should be longer than 10μs. Series connect resistors for current-limiting when +12V or +24V used. The same as DIR and ENA signal.