AQUA 1 HP small electric auto electric water pumpfor swimming pool

>PUMP CONNECTION

Suction line from pool (skimmer and main drain) must be connected to inlet at hair and lint trap.

Discharge line to pool (return lines) must be connected to outlet at top of pump via filter.

>WARNING

During the pressure test procedure this pump is under pressure.

DO NOT LOOSEN clamp or T-handles while pump is running or until all pressure is released.Tighten T-handles or latch securely.Raise pressure slowly .Do not exceed 50 psi.Extreme care must be taken during pressure test.Failure to follow these instructions explicitly can result in personal injury.

>CLEAN BASKET

It is important to clean the hair and lint basket frequently.A dirty basket will reduce the efficiency of the filter and heater and will put abnormal stress on the pump motor which could result in costly repair bills. Do not remove hair and lint strainer lid while pump is running or under pressure!Lid is held in place by a clamp or T-handles which can be removed or tightened by hand.Basket must be kept clear of leaves and debris all the time.