3528 SMD Led Strip Light Dripping Glue Waterproof(60 LED per Meter)

LED Strip PLCC SMD Type Mounted on Flexible PCB


Input Voltage: DC 12V/24V


Color temperature (nm)cold white7000K-7500K;white6000K-6500K warm white3000K-3500K


Luminance (mcd):red: 400-500 yellow: 400-500blue400-500 green: 1000-1300 white1600-1800


Waterproof Material: Silicone hollow tube


Color: cool white, pure white, warm white, red, yellow, blue, green, RGB


Optional: IP45/IP65/IP67/ IP68


LED CHIP: 3528 Made in Taiwan


60 LED Per 1 Meter Strip, Each Strip Connected in Series


With 3M adhensive tape backside for easy installation.


3 units LEDs cuttable for 12V 5/6 units LEDs cuttable for 24V;


Saving Energy Percentage: 88%


LED LIFE 30,000 ~ 50,000 Hours


View Angle: 120


Operating Temprature: - 30 Degree ~ + 50 Degree Celsius Max


Carbon Emission(hrs): 4.466g


Anti-oxidation, anti-UV radiation and wont change color after long time use.


High flexibility ,high transparence, flame-proof and environmental friendliness.


Silicone material offers good heat or cold resistance and is not easily broken.


With silicone transparence waterproof connector can easily connect and totally waterproof


1Solder connection should only be performed on designated solder pads(marked ). During soldering,dont exceed the maximum soldering time of 10 seconds and the maximum soldering temperature of 260 Celsius degrees.


2The smallest unit (3 LEDs) can be removed by cutting with scissors between the designated solder pads.


3The mounting of the strip is facilitated by means of the double-sided adhesive on the back-surface of the strip. Care must be take to provide a clean and dry mounting surface,free of oils or silicone coatingas well as dirt particle. The mounting substrate must have sufficient structural integrity. Take care to completely remove the adhesive backing. Oncethe stipis appropriately positioned. Press on strip with about 20N/cm2(refer to application techniques of 3M adhensive transfer tapes).


4The minimum bending radius is 2 cm. The strip may be bent over a smaller radius of the circuit board containing no electronic components and such bends should be made once and fixedin position to avoid cyclic fatigue.


5After cutting along the line, ifyou want to connect the cutting sections or connect one sectionto power, the connectors will be necessary





interior lighting


exhibit lighting


kitchen-cabinet lighting


Car decoration


Architectural decorative lighting


Archway,canopy and bridge edge lighting


Amusement park,theater and aircraft cabin mood lighting


VEmergency Hallway lighting


Auditorium walkway lighting


Emergency exit path lighting


Cove lighting


Border or perimeter lighting



1Please make LED drivers compatible with waterproof led strips light before use LED strips;


2To use waterpoof led strip light 5M in serial, longer than 5M in parallel;


3Before use,first check the power supply used in compliance with of the power requirements;


4Each roll ask for independent power supply;not to use of multi-volume series use;