Field Control Unit Duplexed Field Control Unit AFV10S AFV10D

Field Control Unit Duplexed Field ControlUnit AFV10S AFV10D (for Vnet/IP, for FIO, 19" Rack Mountable Type)

GENERAL

This GS covers the hardware specificationsof the Field Control Unit (FCU) which is the processor of the Field ControlStation (FCS).

Processor

VR5432 (133 MHz)

Main Memory Capacity

32 Mbyte

Memory Protection During Power Failure

Battery

Battery Back-up for Main Memory: Max. 72hours

Battery Recharge Time: Min. 48 hours

FCU Status Contact Output

2 terminals (NC, C)

Contact Points open during FCU failure

Contact Rating: 30 V DC, max. 0.3 A

Communication Interface

Vnet/IP Interface: Dual-redundant

Vnet/IP Communication Speed

1000 Mbps Full Duplex

Connection Specifications

Cable: CAT5e (Enhanced Category 5 cable)orbetter, UTP

Transmission:1000BASE-T and 100BASE-TX compliance

Connector: RJ45 connector

Max. distance: 100 m (Distance betweenAFV10£ and Layer 2 switch) Autonegotiation

No. of Node Units Connectable

Max. 14/FCU

The total number of the local and remotenodes that can be connected to FCU are 14 or less. (The local nodes: 9 or less)LFS1500 allows up to 3 nodes, and can be expanded to 14 if LFS1530 Applicationcapacity Expansion Package (for AFV10□) is added.

No. of I/O Modules

Max. 8

Local Node Connection

When connecting a Local Node to FCU,install ESB Bus Coupler Module (EC401) on FCU.

EC401 must be installed in slot 7 or slot8. To make single configuration, EC401 must be installed in slot7, and Slot 8must be empty.

Power Supply

(specify with Suffix Codes)

100-120 V AC, 50/60 Hz

220-240 V AC, 50/60 Hz

24 V DC

Power Consumption

100-120 V AC: 200 VA

220-240 V AC: 230 VA

24 V DC: 5.5 A

Weight

Approx. 7 kg (AFV10S)

Approx. 8 kg (AFV10D)

Mounting

19" Rack Mounting:

Rack mount (8 x M5 screws)

Insulation bush (accessory)

AFV10S AFV10S-S3115 AFV10S-S3125AFV10S-S3145 AFV10S-S4115 AFV10S-S4125 AFV10S-S4145

AFV10D AFV10D-S4115 AFV10SD-S4125AFV10D-S4145

S9049PM T9083NE T9083NG