Steel Silo Production Machines

Machine operation steps
Bend bite suture machine- →to bond pillar framework in place–→ machine decoiler in place.
Step1: bend bite suture machine on steel and the cylinder body (the wall) of circles (round a line of school used the coincidence ). At the same time calculated the spiral of the machine, at the end of a leg down under proper pad.
Step2: the prop, the frame before connection,pillar according to the requirements should be adjusted. On the requirements to build silo (pool wall) of circles, the wheel support along the circumference of the projection and point with long term shall coincide with the school (fall). From the bend bite machine counterclockwise, interval 1.6 meters installed a pillars, has been installed at the last root and bite maching bound together form a closed framework. Pillar is building steel warehouse (pool) is the important support parts quality and safety of the important link,therefore in the installation must level (note: with each of the root of spiral liters).
Step3: molding machine in principle on bite machine suture machine clockwise about 5-6 metres near the silos (pool) the inside edge.
Step4: uncoiler in 2-3 meters after molding maching, main effect is the upper placed 495 mm wide plate.
Such HD-40 steel belt molding bite suture until in place finished, already has started  working conditions. But in order to ensure the quality and safety, should also be idle operation commissioning ten minutes to check the working of the machine. And then feed forming 4 meters long two paragraphs. Artificial closed the up and down into the bite, and in two suture machine for the steel plate after the bite bite muscle place, cutting, grinding wheel to see after sampling to bite the quality to have decided to formally boot operation.