Xinyak Absolute Rotary Encoder;position Sensor SSI Output,OEM;Fuyong Port Shenzhen

Inteligent rotary encoder is one of the most commonly measurement components in the area of industrial automation. It mainly used in the electric motor and various automation equipment to detect angle-position and measure speed.We provide various industrial standard increment encoders such as open-collector,push pull output.long-distance drive and so on,which can connect most frequency converters and interface cards.We also provide absolute encoder such as SSI,RS232,RS 485,PI,gray code,binary,multi-circle and so on. For the detail info,please contact sales department. Mechanical Parameter:

Parameter          Value     Unit    Remark

Quality                <180    g        except wires

Working temperature      -40~85       degree  

Store temperature          -50~125     degree  

Protection grade IP55                excellent resistance of water, oil and dust ability;allowing condensation,max IP68

Anti-vibration      <600    m/s2  55-2000Hz

Anti-shock          <4000  m/s2  Impact 6ms, allowing strike lightly during installation

Starting toque    <6*10-3         Nm   20degree

Rotor inertia       <3*10-6         kgm2     

Max shaft load    60         N        radial direction

80         N        axial direction

Axial movement <1.5     mm    measured axial

Mechanical speed            <16000      rpm

Electrical parameter 

Model            XYK-BMJ-38Z6-S12

Working voltage                              5V/ Model       Synchronous Serial SSI output

Output high level                            >4.5V            output low level      <0.4V

Current consumption                     <100mA       MAX Load current    4mA

Resolution                                     12 bit          
Measurement range      0~360deg

CLOCK           0~1MHz                     Working temperature     -40~85 deg

CSn signal input                              Low level <1.5v, High level 3.5-5v      CLOCK signal input      Low level<1.5V,high level 3.5-5v

DATA output  Binary code                                    

MAX Rotating speed                        600rpm         remark      Five-wire: red-VCC,black-GND, yellow-DATA,green-CLOCK,white-CSn

SSI sequence chart:CSn input and CLK input must apply to the above sequence ,specific parameter is following:

COF 
 MAGINC

 PARITY (EVEN)   If CSn changes to logic low level, data output will change from High impedance state to logic high level and start read operation.