Thailand Electronic Ballast Syatems(Ebs)

Specifications: Electronic ballast system is a variable intensity power supply and control system for powering UV lamps. This revolutionary new technology has been granted two patents, with three more pending. The ebs was developed to solve the problems associated with conventional magnetic ballasts. As a result, it is now possible to fully integrate control of the UV lamp with curing system. Control features - fully integrate lamp control with the curing process - continuously variable lamp intensity from 10% to 100% - rapid lamp starts: As little as 10 seconds - PC/plc/pot control compatible - multiple ballast status indicators - operates mercury, gallium or halide lamps Packaging benefits - drop in power supply, pre-wired - broad power range:100 to100,000 watts - more efficient than magnetic ballasts - save energy, reduce heat build up - less maintenance: No high voltage caps or relays - multiple input and output voltage options End user\'\'s gain - precision preduct curing - tailor u. V. Intensity to product chemsitry - no more overcure: Precise undercure when desired - ramp u. V. Output with web/belt speed - reduce substrate heat: Improve print registration - higher production/longer bulb life/lower cost High reliability The ebs replaces high-voltage capacitor banks and mercury-filled relays with a highly reliable electronic control. Reliability of the ebs measured four times better than a magnetic ballast with relays and capacitor banks, based on military reliability prediction methods. Continuously variable lamp power Power to the lamp is continuously variable over a range of 10% to 100% instead of two or three steps. Power is precisely controlled with a potentiometer,0-5v,0-10v, or 4-20ma control signal. The control input easily interfaces to a computer or programmable controller. Simple installation Completely factory pre-wired, the ebs eliminates labor intensive wiring of relays and capacitor banks. The user only needs to connect input power, lamp leads, and a control input. Status indicators Five status indicators show if power is applied, the operating mode (warmup or run), and if a lamp-out or overcurrent fault has occurred. Corresponding relay contacts can connect to a computer or programmable controller. -accommodates a range of different lamps with one ballast model -rapid lamp starting -standard mercury, gallium, or halide lamps -input voltage options 120 v. To 575 v. -automatic 50/60 hz. -reduced size & weight -ahigh efficiency-lower operating costs