Mining Lamp Charging Rack

Usage
1.Installation: fasten the legs of the rack on the ground, it’s generally 5 cm higher than the floor.
2. Switch on AV power supply, the indicator light is on, DC volt meter shows no-load voltage .
3.Turn off the lamp,then inset the lamp cap into chjaring plug and clockwise rotate 180 degree,switch on the charging circuit. When the indicator light is on,it shows normal charging.
4.As initial charging,the current is 1A,please keep charging for 72 hours.Normal charging for 2 hours,the battery current is 2A,but after finishing charging,the current should lower than 0.1A.
5.During charging,if you find the indicator stop or show wrong,you should check the contact parts
6.If the out –power supply cut suddenly when charging,rotate the each lamp cap counterclockwise and cut the charging circuit.
7.Keep all the parts of charging shelf clean and dry.
8.If there is electrolysis fluid leaked,clean it immediately in order to avoid eroding.
9.Often clean inside silican rectifier,keep it clear.
10.There are taps in the rectifying transformer (primary) and assistant transformer (secondary),for users to adjust voltage if fluctuations.
Packing and carriage
1.The Goods are fixed in the box and meet up the loading requires of sea and road,assure not get shock and damage during transport.
2.They shall store in the air moving,rainproof,waterproof,dryness.