Contact Platform Support
Help CenterLiFePO4 Battery 12V110 for Energy Storage
Related Products
-
Lithium Ion 24V 80AH LiFePO4 Battery For E-VehicleUS$ 1,280 - 1,500MOQ: 5 Packs -
48V Lithium Ion Battery Pack, 48V100Ah, 150Ah, 170Ah, LiFePo4 Battery Packs, for Vehicle, for Solar Energy StorageUS$ 3,500 - 5,000MOQ: 1 Set
-
Lifepo4 72v 20Ah Electric Bicycle BatteryUS$ 1 - 2,000MOQ: 1 Set
-
72 Volts 20ah Lifepo4 Battery 72v Electric Bicycle BatteryUS$ 1 - 2,000MOQ: 1 Set
-
SLA Style 51.2V 40Ah LiFePO4 Battery With RS485US$ 1 - 2,000MOQ: 1 Set
LiFePO4 Battery12V110
1) Ultra-long life cycle vs SLA battery
2) Lighter weight and Smaller size vs SLA battery
3) Stable output vs SLA battery
4) Fast chaging & discharging is available vs SLA battery
5) Enviromental friendly
Specification
Item |
Comments |
Battery module |
110Ahr or 1408Whr (316PCS IFR18650EC-1.5Ah cells in a 4S79P configuration. Or 136PCS IFR26650EC-3.3Ah cells in a 4S34P configuration ) |
Approx. Dimension |
260 mm x 158mm x 246 mm (L*W*H) |
Approx. Weight |
15.1kg |
Nominal voltage |
12.8V |
Maximum voltage |
14.6V |
Minimum voltage |
10.0V |
Nominal load current |
150A max. continuous current @ 23° C |
Peak load current |
300A max for 30 sec @ 23° C |
Charge protection |
When the Battery modules are charged to full, they will communicate with BMU, and the BMU has the capability to turn off the charger or open the main contactor. The battery module itself does not have any switch to disconnect the charger. |
Balancing |
The intra-module balancing circuit is used to compensate slight capacity imbalance among the four cell blocks within a battery module. The inter-module balancing circuit is used to compensate slight capacity imbalance between different battery modules in series connection. |
State of Charge Measurement |
Individual cell block voltage and charge/discharge current will be used to monitor the state of charge (SOC) of the battery module. The estimated capacity used for the calculations will be adjusted to meet the capacity of the lowest capacity cell block when the battery system is fully cycled. The state of charge will be adjusted for normal self discharge of the battery system when the unit is not on charge. |
RS-485 Communication Uplink |
RS-485 Communications will be used to communicate with the Battery Management Unit (BMU) or connection to other battery Modules. |
RS-485 Communication Downlink |
RS-485 Communication connection from Downstream battery module. |
RS-485 insulation voltage rating |
1414V , 5000V rms for 1 minute |
Status LED |
A Dual LED on module to indicate working status. One is green and the other one is red. Blinking of the green LED indicates that the module is working properly. Blinking of the red LED indicates that the module has failure and needs service. |
Send Inquiry to This Supplier
You May Also Like
-
Storage BatteryNegotiableMOQ: 2000 Sets
-
Untested Scrap Recycle Computer Hardware Used Laptop BatteryNegotiableMOQ: 10000 Pieces
-
32900 Rechargeable LiFePO4 3.2V 5500mAh Battery Cell for EnergyUS$ 4.5 - 5MOQ: 2000 Pieces
-
BATTERY FOR NDS NDS LITENegotiableMOQ: 10 Pieces
-
Sealed Lead Acid Dry Charged Battery 12v 4ah Battery for MotorcycleUS$ 5.33 - 5.9MOQ: 300 Pieces
-
Solar Generator With the Lithium-ion Battery S-1207US$ 20 - 500MOQ: 100 Pieces
-
12V Battery UPS Li-ion Battery Solar BatteryUS$ 60 - 78MOQ: 1 Piece
-
AGM Battery Separator Glass Fiber MatUS$ 1 - 10MOQ: 100 Kilograms
-
25C 3S Lithium Ion Battery 12V 11.1V 900mAh 3cell for Align KX019011 T-Rex 250 PROUS$ 1 - 100MOQ: 100 Pieces
-
12 Solar Light Lights AA 800mAh Rechargeable Battery Batteries Long Lasting 3 PaNegotiableMOQ: 3000 Pieces
