Kingsk8 Precision 8mm x 10mm Bearing Spacers

Spacer for Skateboard And Inline Skate And Skate 

Kingsk8  Precision Bearing Spacers will help your ride and slides be as smooth as possible. These burly spacers can withstand higher pressure without buckling or deforming, as well as allowing the bearings to fit snug in the bearing seat. Unwanted slop and noisy bearings can finally be a thing of the past!

8mm x 10mm spacers will fit almost all standard wheels. If you are using 10mm axle trucks.

If you have been considering adding skateboard bearing spacers to your board, you should read the following:

Adding spacers in between your bearings will align the bearing to the inner hub of your wheel. This will effectively reduce friction and movement inside the hub of the bearing. With spacers installed, the energy between turns is absorbed by the wheel and not the bearing itself, reducing impact and side load on the be bearing itself.

Reducing stress on your bearing components will help prevent your bearings from exploding or seizing up while riding your board. In addition to stress reduction, adding spacers will hold your wheels steady on your trucks during slides, preventing that annoying and sometimes dangerous choppiness experienced when sliding square-lipped wheels.

If you are doing any Racing, Downhill, Freeride, and especially Slides and hard carves, you will want to add Bearing Spacers to your Skateboard.

8mmx10mm bearing spacers. 

Pack contains 4 spacers (enough for 4 wheels)