hot-selling gypsum powder production plant

Specifications

gypsum plaster production plant with high level of gypsum powder production technology
1. first grind, second bake

Gypsum plaster production plant 

With the development of gypsum industry, there is a large demand for quantity and high quality of gypsum powder. Therefore, the high level of gypsum powder production technology is required. In the process of gypsum powder production, drying and dewatering is the key link, which is also the most difficult one to control. In order to solve this problem, we develop a new type of drying and dewatering equipment---ebullience calciner, which is produced based on the exploring of the gypsum production filed. Following is the brief introduction of the gypsum production technology and ebullience calciner working principle.

 

The technology of gypsum powder production:

The main composition of gypsum is hydrate gypsum(CaSO₄.2H₂O). however, the gypsum powder used in practical production(such as the gypsum powder for gypsum board, for mould, for plastering)is to dry and dewater the dehydrate gypsum which of certain fineness, reduce the content of crystallization water in it, so the standard of crystallization of gypsum powder can qualify all kinds of gypsum powder, because it can change into plaster of pairs. Plaster of pairs can re-integrated with water when it is applied into production, and it can be processed into new type building materials with a high intensity, such as gypsum board, gypsum block, etc.

Existing gypsum powder drying technologies are frying boiler and rotary kiln plant. It means that put the gypsum powder into the frying boiler and coil pipe, and before the gypsum powder was put, the heat produced by the burning of the medium in kiln furnace was send into the frying boiler and rotary kiln plant by fan. In this way, the quality of gypsum powder is difficult to guarantee, because the content of crystallization water is uneven.

New-type gypsum frying boiler- ebullience calciner

First grind and second bake. The largest advantage of this technique, compared with that of “first grind and second bake”, is energy consumption reduction. Large plaster stone shall be ground into powders with diameter less than 0.2mm, which increases the specific surface when calcining, enlarges the contact area with heat medium, improves calcination heat exchange efficiency and lowers energy consumption greatly. This equipment has small bulk, large production capacity, and simple structure and is hard to destroy.

The equipment configuration table fluidized furnace

Daily output (T)	Volume of fluidized furnace (M)	Roots blower (KW)	Electrostatic precipitation (	Thermal conductivity oil furnace	Auxiliary equipment	note
150	1.3	11	4	200	Hoist, root blower, feeder conveyor, frame body
200	1.4	15	5	300
300	1.6	18.5	6	500
400	2.0	22	8	600
500	2.4	30	10	800

Note: in addition to the above mentioned equipment, we also provide the design for the entire production line and auxiliary equipment election. We will send technical engineer to the buyer’s site for installation and debugging machine until the quality gypsum is produced.