Skin Regeneration Multifunctional RF Co2 Fractional 10.6um Laser Machine Scar And Pigment Removal

Fractional Co2 laser treatment:

Ultrapulse fractional co2 laser emits thousands of deep, tiny focal spot columns in your skin, called microscopic treatment zones. These lights penetrate into dermis skin, gasify the tissues around wrinkles and scars in an instant and make a signal of compounding collagen like tissues repair, collagen rearrangement ettc to regain a new fresh and healthy skin of youth.

Multifunctional RF Co2 Fractional Laser Machine Scar and Pigment Removal

Fractional Co2 Laser is utilizing the most advanced micro-lens technology, which allows laser system to produce a large number of ultra-pulsed beams, these ultra-pulsed beams act on the skin to form a diameter of 0.12-1.25mm, depth of 0.1-1mm micro-hole, so that a large number of micro-invasive skin area (micro thermal zone) and heat accumulation zone or micro-heating area are formed, they also can form regional gasification that act on the skin pigment organization, while the heat’s accumulation in the dermis will make collagen protein do immediate skin contraction, and proliferate the collagen, then achieves the effect of wrinkle removal, scars removal, skin rejuvenation, Laser Vaginal Tightening and solve skin problems and abnormal pigment removal.

Treatment Range Co2  Laser

1. Laser wrinkle removal
2. Laser scar removal
3. Syringoma and steatoadenoma removal;
4. Seborrheic keratosis and actinic keratosis treatment;
5. Skin Rejuvenation
6. Striae gravidarum removal
7. Vaginal rejuvenation available

Advantages:

1. Used both on the epidermis and dermis;
2. No ablation and no intervention to skin;
3. The risk of formatting scar and pigmentation has been largely reduced;
4. Do not influence your common work;
5. Long time keeping and short time recovery and with sequel;

Technical Parameters:

Before & After Co2  Laser

Raynol (Beijing) Technology Co., Ltd. is a supereminent professional manufacturer, which specialized in medical & beauty Laser devices such as Q-switch Nd:YAG Laser, IPL Machine, E-light Machine, RF Machine, Fractional Co2 Laser, 808nm Diode Laser Hair Removal Machine, Fat Freezing Cryolipolysis Machine, IPL SHR Laser, RBS Spider Vein Removal Machine, Fractional RF Microneedle, Laser Hair Growth Machine and Cavitation Slimming Machine etc.

1. How does FRACO2 work?
Fraco2 works by producing columns of laser beams which precisely penetrate to the level of wrinkles or scars, and stimulate your own skin to replace the old collagen with new “baby” collagen. In between the laser beams, the skin remains intact, allowing healing to occur quickly.

2. Who is suitable for Fraco2?

1. Moderate to severe facial wrinkles

2. Moderate wrinkles neck, hands

3. Sun damage and brown spots

4. Acne and other Scarring

3. What does the treatment involve?
The treatment involves using the laser over a complete area or whole face. It is not suitable for a single wrinkle line or fold.

A numbing cream is applied to the area for at least 1-2 hours prior to treatment, and in some cases local an aesthetic injections are used. Pain puffers and medication can also be used if needed.

The laser is applied to the affected areas. At the end of the treatment the area will look like small white  or red dots that disappear by the following day. There is usually redness that lasts at least 7 days, and swelling for a few days. Most people need  about 5 days off work.

4. How many treatments will I need?
Depending on the degree or wrinkling or scarring and your expectations, you would usually need 1-3 treatments. Some people need more, especially those with severe acne scarring.

5. Is Fraco2 painful?
Pain really depends on how strong you use the Fraco2 laser. In most cases, it is essential to use at least a numbing cream, and often local anaesthetic injections are also used. For increased comfort, pain puffers and other painkillers may be used.
After the treatment, there is some discomfort for about 1 hour. It is best relieved by using ice, cold air, or cold compresses.

6. What do I look like after the treatment with Fraco2?
Immediately after the treatment you will look red, with tiny white dots, or pinpoint bleeding on your skin. These dots usually disappear the next day. Swelling will last a few days and redness at least 7 days. You can apply makeup usually after 3 days, but you  usually need a few days (5-7) days off work.

7. What do I do after the treatment?

1.Take antibiotics to prevent infection (depending on the doctor’s decision)

2.Use light non greasy moisturizer and sunscreen, the clinic will recommend one that is suitable for your skin.

3.You may wish to take anti swelling tablets for a few days.

4.You may wish to use compresses with white vinegar and water for the first 24 hours to reduce swelling.

5. Apply makeup after the a few days.

Features:

1. Reduced thermal damage to surrounding tissues

2. Rapid healing and minimal downtime

3. Stimulate deeper collagen with high pulse energy

4. LCD display panel provides easy operation with the latest microprocessor technology

5. Adjustable scanning patterns and size

6. Adjustable intensity of pilot beam from zero to maximum

7. Adjustable pulse duration

8. Last treatment setting memorization

9. Automatic alarm system for operation and troubles

10. Covers all functions of conventional system

11. No consumable costs  

6. Wash your skin with a gentle cleanser eg Cetaphil lotion.

7. If you have darker skin, you may need to use a bleaching lotion after the treatment to prevent post treatment increase in skin pigmentation.

8. What sort of result can I realistically expect?

1. Fractional resurfacing is a new laser treatment modality that creates numerous microscopic thermal injury zones of controlled width, depth,and density that are surrounded by a reservoir of spared epidermal and dermal tissue,allowing for rapid repair of laser-induced thermal injury. This unique modality, if implemented with proper laser- delivery systems, enables high-energy treatments while minimizing risks.
   2.This machine use the RF Tube manufacturerd by Coherent America,the frequency can reach more than5000HZ,the high speed can work more efficiecnt and effectively,it is very good for the ultra pulse incision for the precise surgey,no blood,the treatment area is very clear,andless down time.

2.