Cold-Applied Boot up to 17.5kv
Cold-applied boot is moulded insulation to cover live parts of the bushings, they are suitable for the connection of the cable lug and the inline or right angle of switchgear or cable sector which can improve phase-to-phase and phase-to-ground insulation. They are used to ameliorate insufficient of the air clearances for normal operation, the clearances are adequate to keep the air entrapped well below corona extinction level or to prevent the flashover due to rodents or high humidity. They also can withstand normal and surge voltages induced during operational life of termination systems.
Send Inquiry to This Supplier
You May Also Like
-
Power FittingNegotiableMOQ: 2300 Pieces
-
W Type of Socket ClevisesTypesUS$ 1 - 100MOQ: 1000 Sets
-
Favorites Compare Stay Bow and Stay RodUS$ 1 - 2MOQ: 100 Pieces
-
ALUMINIUM DIN RAIL (G32-15L)US$ 0.52 - 0.6MOQ: 10000 Meters
-
Power FittingUS$ 3 - 15MOQ: 1000 Pieces
-
Gas Tube ArresterNegotiableMOQ: 1
-
Insulating Piercing Connector IPC Cable Clamp, Clamp Connector Wire ConnectorUS$ 2 - 10MOQ: 10 Pieces
-
Forged Electric Power Fitting PartsUS$ 1.1 - 2MOQ: 1000 Pieces
-
Frp Crossarm PriceNegotiableMOQ: 100 Meters
-
Dead End Clamps for 4 Wires Wire and Cable Plastic Wedge Type Anchor Strain Clamp Tension ClampNegotiableMOQ: 500 Pieces