Vacuum Plastic Sucking Adhesive

Specifications

Vacuum plastic sucking adhesive 9906

1. Technical indexes:

2. Applicable requirements:

1.Wood substrate requirements : moisture requirements of 8 to 12%, flat sheet, plate surface formation, not loose fiber meticulous, 0.7--0.8g/cm3 density, spray glue on the substrate prior to the art of pictorial inside jet dust blowing static. 

2.Glues 40-70/m2 volume : planar, cross section, profile 80-100 (the proposed coating twice).

3.Lance caliber of 1.5-2.0mm around.

4.Lance best 0.3--0.4MPS air pressure, gas flow should be redeployed to Lance, atomizing effect. Gum ever spray fan.

5.PVC plastic film softening temperature of about 110 °C.

6.PVC plastic film useful in peace stickers and two types of vacuum forming, not all films are suitable for vacuum forming. Usually peace stickers are 0.25mm thickness of the film, heat shrinkage also larger. Vacuum forming the film thickness are above 0.25, heat shrinkage also small. Most coating on the back, reached 34-36 dyn/cm surface tension. 

7.Film activation temperature must reach above 60°C, adhesive bonding strength can be the best.

3. Precautions :

1.Hard plastic film composite, the use of composite pressure relatively short time, the relatively high temperature composites.

2.Composite soft plastic film, the use of composite pressure long time, a relatively low temperature composites.

3.Pad height of not less than 8 mm, and working conditions must be at least generally high.

4.Working conditions must be greater than the distance between the plate height, thickness and work conditions.

Vacuum plastic sucking adhesive 9906

1. Technical indexes:

Model Vacuum plastic sucking adhesive

Characteristics Cost-effective, high bonding strength and excellent heat, atomizing effect.

Application Heat applied to PVC plastic and other medium-density fiberboard, particleboard thermal compound. Applicable to all types of vacuum compression molding machine, such as kitchen utensils and the whole kitchen doors.

Appearance Milky white liquid

Viscosity range 300-700mpa.s

Solid content 45%-48%

Packing 25KGplastic drum

2. Applicable requirements:

1.Wood substrate requirements : moisture requirements of 8 to 12%, flat sheet, plate surface formation, not loose fiber meticulous, 0.7--0.8g/cm3 density, spray glue on the substrate prior to the art of pictorial inside jet dust blowing static.

2.Glues 40-70/m2 volume : planar, cross section, profile 80-100 (the proposed coating twice).

3.Lance caliber of 1.5-2.0mm around.

4.Lance best 0.3--0.4MPS air pressure, gas flow should be redeployed to Lance, atomizing effect. Gum ever spray fan.

5.PVC plastic film softening temperature of about 110 °C.

6.PVC plastic film useful in peace stickers and two types of vacuum forming, not all films are suitable for vacuum forming. Usually peace stickers are 0.25mm thickness of the film, heat shrinkage also larger. Vacuum forming the film thickness are above 0.25, heat shrinkage also small. Most coating on the back, reached 34-36 dyn/cm surface tension.

7.Film activation temperature must reach above 60°C, adhesive bonding strength can be the best.

3. Precautions :

1.Hard plastic film composite, the use of composite pressure relatively short time, the relatively high temperature composites.

2.Composite soft plastic film, the use of composite pressure long time, a relatively low temperature composites.

3.Pad height of not less than 8 mm, and working conditions must be at least generally high.

4.Working conditions must be greater than the distance between the plate height, thickness and work conditions.