Botou Cangzhou China Anode panel roll forming machinery of environmental

1.Technical specification

 Pass:10passes-11passes 

Shaft diameter: 70mm

Width range:       1000mm

Thickness range:      0.3-0.8mm

 Inner diameter range:    500mm

Speed of product:          8-12m/min 

Roller material:45 steel(Cr coating)

Total power:4KW 

Control system: PLC

 2.Processing technique and deployment

 3.Components of line:

 (1)   man-made uncoiler   (max capacity 5000kg)

(2) Roll-Forming:

Steps:10-11steps         Roller Material: 45# steel

 Voltage: 3phase/80V/50-60Hz.   line speed:8-10m/min;

 Rolling chromium thickness:0.05 mm     

(3) blade 

It adopts hydraulic drive and automatic location to decide the dimention and cut the target products.

 Match equipment : one set of cutting tool, one hydraulic tank ,one cutter machine.

 Stop to cut , Post cut     cutting length tolerance: ±2mm

 Cutting tool material: GCr12 with quenched treatment 60-62°C

 (4) Hydraulic System

 It is controlled by gear wheel oil pump. After filling the hydraulic oil into the hydraulic oil tank ,the pump drive the cutter machine to begin the cutting job.

Match equipment: a set of hydraulic tank , a set of hydraulic oil pump, two hydraulic pipes and two sets of electromagnetism valves. 

 (5)control system :

 It adopts PLC to control. The target piece length is adjustable and digit of it can be adjusted

Computed mode has two modes: automatic and manual one.

(6) receiving table: 

1. T/T , L/C  2. 30% Advanced pament first and the lest paid after received loading bill copy.

                                                      All the packaging of machine above can be arraged as customers' requirement.