Good quality t8 led tube with motion sensor

Operation A

  When human movement is detected within a 4m radlus(120° angle of sight) of the PIR sensor, the LED tube will turn on to its 100% level.

Operation B

  If no human movement is detected, after preset delay time(ranging from 10 seconds to 10 minutes), the LED tube light will turn to standby mode(normally 30% brightness level)

Installation method:

1. Pay attention to the direction angle,or the induction distance will be affected.Make the square window and most human activities direction parallel as much as that the induction effect gets better

2.Environmental temperature not higher than 35 DEG C, when the environment temperature rises and the human body surface temperature approached (30 to 35 DEG C), the detection distance will be slightly shorter, this belongs to the effect of a temperature factors

3.Should be installed to avoid light interference source near distance lens direct module surface, to avoid the introduction of jamming signal generating misoperation; the use of the environment to avoid the flow of wind, the wind also can cause interference in sensor.

Notes

1.Ensure that the installation of detection area in the range of 5-8M, and no any body temperature more than 35 DEG C

2.Check the power supply, the connection is correct

3.The sensor is not suitable for direct installation in ordinary combustible materials on the surface.

 Used especially for night lighting, such as lift,stairs,and public toilet,etc.

Package information for 3 different length: 

1. Customize services are available when needed. 

2.Best Solutions for customer in Project 
3. Free replace during Warranty time                                    
4.Quick action of technical support and maintenance.