Self-adhesive Bitumen Waterproof Flashing Tape

Specifications

Flashing tape

thickness, 1.0mm-2.0mm 
width,50mm - 1000mm 
length,2.5m - 20.0m 
color: bright alu, gray alu, red alu, black PE, HDPE

Flashing tape Application 

Vehicle maintenance and repair,   sealing around pipes and tanks,  repairs to weatherproof enclosures,  sealing over wood,  concrete brick most metals and some plastics,

flashing of conservatories and porches,  roof skirtings and parapet joints,  sealing of skylights, vents, pipes, window sills and other openings,  repair bandage for gutters and roofs,  sealing glazing bars,  cappings and protective coverings.

window and door openings,   corner boards,   deck-to-wall intersections,   foundation and sheathing sill splash back areas, sheathing panel seams,   under stucco finishes, deck joists and other detail areas.

Flashing tape Characters:

1. Self adhesion without bonding agent and torching. 

2. Good rubber elasticity and elongation 

3. Excellent binding power 

4. Good self-coalescence 

5. Safe application, no pollution

6. Excellent waterproof ang high strength

7. Corrosion resistance and ageing-resistance

8. Available for wet ground

  Contractor guidance

1. Ensure that the surface is dry and free from dust, rust and loose materials.

2. Prime porous surface e.g. concrete and brick with a bitumen primer or black, bitumen paint, thinned with white spirit, which is allowed to dry.

3. Cut the flashing tape to the required length.

4. Peel back 5cm (approx) of the release backing paper and position carefully. Continue removing the backing paper whilst firmly placing the tape to avoid unnecessary creasing.

5. Smooth down so that the overall contact is complete, and ensure that all air bubbles are removed. Take care not to damage the surface of the tape.

6. Where tape is joined, ensure that there is an overlap of at least 1inch or 2.5cm .

7. After use release pack and store upright in cool and dry conditions.