hotel bathroom lock, bathroom lock, door lock

hotel bathroom lock, bathroom lock, door lock

1. hotel RFID lock Data sheet 

2. How ORBITA hotel locking system works?

Our hotel locking system consists of following:

- PC (usually located on the reception desk of hotel lobby)
- Hotel lock management software+Encoder (How the cards are issued)
- Hotel card lock (Installed on the hotel room door)
- Cards (The keycard to open doors)

3. Card function:
-Guest card:Reception complete program Guest card by give a begin and expiry date for a room(rooms).Guest access room by -read this card on lock 
-Master card:Hold by housekeeping to access to all rooms of hotels 
-Floor card:Hold by clean staff to enter the rooms in one floor. 
-Building card:Hold by manager to enter the rooms in one building 
-Passage card:Once this card been read on one door,this door could be acceess by without reading keycard 
-Emergency card: Enter the all rooms

4. Error Indications and Solutions 

Q:Red light flashing two times with two “beeps”, it means the card belongs to other doors. Or when using the staff maintenance card-→opening times used up.
A:Use the right guest card to open door, or issue new maintenance card.
Q:Red light flashing three times with three “beeps”, it means the card time is not match with the lock time.
A:Guest card expire-issue new guest card, or update lock time.
Q:Red light flashing four times with four “beeps”, it means the lock hasn’t been authorized.
A:Issue a Function Card to authorize lock.
Q: Red light flashing five times with five “beeps”, it means the card has been suspended.
A: If former card suspended, this card can’t be used .Use new card.
Q: Red light flashing six times with six “beeps”, it means the lock is deadbolt working.
A: When lock deadbolt, only guest card and master can open door.
Q: Red light flashing seven times with seven “beeps”, it means the lock was been blocked by the block card.
A: In this case, only master card can open the lock. Or you can show block card again to lock to release it
Q: Red light flashing eight times with eight “beeps”, it means the lock was authorized by function card from another system.
A: If you don’t know the code, you need to reauthorize the lock mandatorily.