Contact Platform Support
Help CenterSolar Grid Connected Inverter/Solar Grid-tie Inverter/PV Grid Inverter/Solar Inverter
Related Products
-
Solar Grid Connected Inverter/Solar Grid-tie Inverter/PV Grid Inverter/Solar InverterNegotiableMOQ: 1 Set -
Xantrex 1800W 24V Solar InverterNegotiableMOQ: 1 Unit
-
Xantrex 1800W 24V Power InverterNegotiableMOQ: 1 Unit
-
Solar Grid Tie Inverter 5000WNegotiableMOQ: 1 Set
-
Xantrex 1800W Power InverterNegotiableMOQ: 1 Unit
Specifications
Solar Grid Connected Inverter/Solar Grid-tie Inverter/PV Grid Inverter/Solar InverterThe StecaGrid 9000 3ph UniString inverter was
developed especially for larger solar power systems.
It is primarily designed for use on industrial
roofs, agricultural buildings and ground-mounted
systems, in each case with identical module
orientation and without shadow problems. The
StecaGrid 9000 ph supports the creation of systems
from 10 kWp to several hundred kWp.
Always symmetrical
The advantage of three-phase feeding is that the
produced solar capacity is always symmetrically distributed
on all three power conductors to the public
power grid. This is the case across the whole output
range offered by StecaGrid 9000 ph. When designing
a system, the laborious avoidance of an asymmetry
through the appropriate selection of separate
inverters is thus dispensed with. Symmetrical feeding
is greatly in the interests of energy supply companies.
Lengthy discussions with such companies are therefore
a thing of the past.
Long service live
While the voltage passes through zero on the gridfeeding
phase, single-phase inverters must temporarily
accommodate all energy supplied by the solar
modules within the device. This is usually realised by
electrolytic capacitors. These components influence
the service life of an electronic device, due to the possibility
of drying out.
With three-phase inverters, energy is fed into the grid
on at least two phases at all times. Thus, the necessity
of intermediate storage of energy in the device
is greatly reduced, which is of benefit to the system
operator with regard to a longer service life.
Flexible connection
Due to the wide input voltage range of 350 V to
800 V, and a maximum input current of 32A,
all commonly available crystalline solar modules can
be connected to the StecaGrid 9000 3ph in various
configurations. Five plug/socket pairs are available for
flexible, mechanical DC connection.
Easy handling
Despite its high output, the StecaGrid 9000 3ph is
a wall-mounted device. Thanks to the high degree
of protection, this inverter can be installed indoors
or outdoors. Due to the integrated DC circuit breaker,
installation work is made easier, and the installation
time is reduced. It is not necessary to open the
StecaGrid 9000 ph during installation.
Send Inquiry to This Supplier
You May Also Like
-
ALLEN-BRADLEY 20BC072A3AYNANC0 PowerFlex700 AC DriveNegotiableMOQ: 1 Piece
-
Anti-flaming Frequency VariatorUS$ 1 - 10000MOQ: 1 Piece
-
Power InverterNegotiableMOQ: 2500 Pieces
-
2014 High Quality Pure Sine Wave Power Inverter 12v 220vUS$ 1 - 1,000MOQ: 100 Units
-
E82EV751_2C E82EV751-2C InverterUS$ 1 - 2MOQ: 1 Piece
-
New 10A 12V 24V 36V DC Electric Motor Speed Controller for Electric Motor PWM Control DC Motor DriverUS$ 1 - 100MOQ: 100 Units
-
1000W Pure Sine Wave Power Inverter DC 12V to AC 230V New Car Caravan A1766US$ 90.93 - 91.53MOQ: 300 Pieces
-
12 Volt 220 Volt Inverter, Pure Sine Wave Inverter, Dc to Ac Power InverterNegotiableMOQ: 1 Piece
-
Irrigation Equipment Center Pivot Parts of Frequency Convertor & Pressure Sensor SystemNegotiableMOQ: 1 Set
-
Sell el Inverter DriverUS$ 2 - 12MOQ: 5 Pieces
