Fire Alarm Bell Compatible With GST Control Panel
Fire alarm bell
SA-B01 Fire Alarm Bell
Specification:
1.Base Material:
a>Iron Base
Size:φ100mm/150mm
b>Aluminium Base
Size:φ150mm/200mm
2.Operating Voltage:Dc24v/220v
3.Working Current:≤25ma
4.Audio Alarm:≥95db
installation note:
1.remove a gong
2.wire the bell in the circuit
3.mount bell mechanism on 4" square standard outlet box with the striker facing down
4.replace a gong
5.the bell must be mounted a minimum of 8ft.,above the floor,or.
6.as close to the ceiling as possible
7.polarized bell provide red(+) and black(-) lead wires
8.when you install the bell,must be observed the polarity

Send Inquiry to This Supplier
You May Also Like
-
Alarm Host & Receiver Control PanelNegotiableMOQ: 3000 Sets
-
Mini 2 Zones Fire Alarm Control Panel Security Host Master Panel FACP Small Conventional Control PanelUS$ 60 - 65MOQ: 1 Piece
-
Commercial Security Wired Wiress Bus Zone Alarm Panel Alarm Host Security Controller SurveillanceUS$ 159MOQ: 1 Set
-
Multifunctional Hydraulic Control ValveNegotiableMOQ: 1 Piece
-
230V/50HZ Massage Bathtub Control Panel Own Multifunction Control Panel With Electronic BoxUS$ 50 - 70MOQ: 100 Pieces
-
1 Loop Addressable Fire Alarm Control Panel With 324 PointsUS$ 1 - 500MOQ: 1 Piece
-
Pull Station Fire Alarm Control Panel for Fire FightingUS$ 10 - 20MOQ: 300 Sets
-
4 Detection Zones Automatic Gas Extinguisher Control Panel for Fire Suppression SystemUS$ 1 - 350MOQ: 10 Pieces
-
Best Price 16/ 8/ 4 Zone Conventional Fire Alarm System Control PanelUS$ 138 - 160MOQ: 50 Pieces
-
4 Zone Fire Alarm Control Panel AW-CFP2166-4-8US$ 1 - 500MOQ: 1 Set




