Wear&slip resistant ceramic lagging rubber belt driving pulley for the sea port

Specifications

wear and slip resistant ceramic lagging
1.Five own facotries
2.Manufacturer
3.CE AND ISO
4.mining,port ,coal,cement

 

Wear&slip resistant ceramic lagging rubber belt

 

There are many high alumina ceramic pulley lagging lined belt rollers in the steel industry, cement,mining ,port and so on. Usually,the rollers are wrapped by a layer of rubber to prevent

them from slipping. But usually,if the roller works in the water environment, the material are easy

adhere to the belt or roller. Then it can be easy slip.

 

Our Kingcera ceramic pulley lagging rubber sheet are adopt the new methods. We valcanized the grain shaped ceramic into the rubber and wrap onto the roller. it not only prevent the roller from slip, can also prolong the roller's service life span.

 

Advantages:

 

1.The rough surface of ceramic pulley lagging, prevent the belt and roller from slip.

2.Abrasion resistant, it can prolong the service life span 10 time at least.

3.Gutters between the ceramic are good for draining away water.

4.Easy installation

 

Applied industry:

The abrasion resistant ceramic lagging mats are widely used in the mining milling,smelting,port , cement ,steel ,chemical , coal fired thermal power plant .

 

 

The performance testing report for abrasion-resistant ceramic lagging

 

 

The performence	Content of AL2O3	≥95%
	Density	≥3.6 g/cm3
	Rockwell hardness	≥85 HRA
	Rupturing toughness	≥5.0MPa.m1/2
	Compression-resistant strength	≥850MPa
	Bend-resistant	≥290MPa
	Pull-apart strength(MPa)	≥7.5
	Pull-apart prolongation(%)	≥300
	Shore hardness	55-65
	Permanent deform(%)	≤24
	Adhesion of the adhesive agent and the ceramic(MPa)	≥3.0
	The form service life of the adhesive agent	≥15
	Temperature-resistant	≤250°C
	Coefficient of conducting heat.	20w/m.k
	The performance to be nonflammable	excellent
	Coefficient of heat-expandability	7.2×10-6m/m.K

 

  Size for Mining and Steel industry

 

500*500*16mm	8mm rubber+8mm ceramic
500*600*16mm	8mm rubber+8mm ceramic

 

 

 

The making procedure of the alumina ceramic tile

2.The pressing of alumina ceramic powder

3.The firing of the alumina ceramic tile

4.The checking for the alumina liner or the rubber

5.The installasions

 

 

6.The Applications

7.Our Exhibitions and customers

 

Looking forward to your great inquiry ,we'll give you our best service ..